Building Playmobil James Bond Aston Martin DB5

Quick Answer

Assemble the Playmobil 70578 James Bond Aston Martin DB-5 by sorting parts first, then following the numbered bag sequence. Pay extra attention to the ejector seat mechanism and figure accessories to avoid rework.

Step-by-Step Assembly Guide

1. Sort Parts by Bag: Open all bags and sort pieces by color and type. The numbered bags correspond to build stages. Common mistake: mixing bags leads to hunting for small parts later. Use small containers to keep each bag's parts separate.
2. Assemble the Chassis First: Snap the main chassis pieces together, ensuring the wheel axles click fully into place. Misalignment here will make the car wobble. Test the wheels roll freely before moving on.
3. Install the Ejector Seat Mechanism: Attach the spring-loaded seat base to the chassis. Push the seat down until it locks. Common mistake: forcing the seat before the spring is aligned, which can break the plastic tab. Check the spring sits flat before pressing the seat down.
4. Add the Body Panels and Chrome Trim: Fit the side panels, hood, and rear section. Press chrome trim pieces gently—they are decorative and can snap if over-tightened. If a trim piece feels tight, check for a trapped part underneath.
5. Apply Decals and Accessories: Peel and place the license plate and any included stickers. Attach the figures' accessories (hat, briefcase, etc.) after the car is complete to avoid losing them. Use tweezers for small decals to keep them straight.

About the Set

• Playmobil 70578 James Bond Aston Martin DB-5 Goldfinger Edition Car: Includes 3-inch articulated James Bond, Auric Goldfinger, Oddjob, and a henchman figure. You get a full scene from Goldfinger in one box, so the build isn't just the car—it's the whole story setup.